Shop E Store A guide on how to restart or restart the factory of your ring.
Estimated reading time: 4 minutes
Devices configuration is usually relatively simple these days. Most applications will give you step by step that detail what you should do, almost holding your hand to ensure that you are not wrong.
When you set a ring video bell, for example, it even tells you to turn off your main electricity supply before starting to wire one to make sure you don’t lose any vital step.
However, when it comes to restarting a device, it is not always so simple and there are times when it is necessary to restore a device.
You may have some connection problems and need to restart. Or maybe you want to be a good friend and give away an older device after updating a new model, for example.
If your video ring is applied to you, here is a step -by -step guide on how to restore the factory of your ring videos.
What you will need
- Your ring videos
- Your smartphone or tablet
- The ring application
The short version
- Find the rest button on the video bell of your ring.
- Press the Reset button to enter the configuration mode.
- Press the Reset button again to connect again.
- Open the ring application.
- Touch the three lines in the upper left.
- Select the bell of your ring video.
- Select TE ‘Device settings’.
- Touch ‘general configuration’.
- Touch ‘Delete the device’.
The first thing that must be taken into account is that when a ring video bell restarts from the factory, it also restores all configurations and images. Then, before following the fast steps from above or the most detailed steps below, make sure you have saved any footage you have and want to maintain.
Video bells cancel the intruders, but also choose some good value things occasionally, so be sure to save any evidence that your other half falls into the bush after a couple of drinks, for example, or anything else that I can need.
You must also ensure the bell of the video of the ring that is restoring the application of the ring if it does not plan to use it again, maybe it has updated from the ring of the ring of the ring, in addition to the ring battery, V vide videos for example, or have your data by hand so you can restore it.
The last thing to keep in mind is that the specific restoration steps will depend a bit on the video bell it has, and let’s be honest, there is much. However, the main process is the same, so things should not differ too much from the steps we have listed below.
Time is needed: 5 minutes
- Find the restart button
The first thing you should do to restore the bell of your ring video is to find the restart button. Now this will vary according to the model you have. We have the video of the ring in hand for this step by step and the restart button is behind the face plate to the top of the camera lens to the right. Depending on the timbre of the video of the ring you have, you can find it on the side of your device, under the face plate or on the back of the device.
- Keep the restart button pressed
Once you have located the restart button on the bell of your video ring, press and keep it to restore the timbre of your ring video. It is a fast process. The lights will begin to blink around the button and should tell you that it is in configuration mode. If you press and hold the restart button again, it will be connected again to your Wi-Fi, effectively restarting it instead of restoring it.
- Remove from ring application
If you do not press the restart button for the second time, and the bell of your ring video remains in the configuration mode, the next step is to remove it from the application of the ring. To do this, open the ring application, press the three lines in the upper left and touch ‘device configuration’. From here, select ‘General Configuration’ and ‘Delete the device’.
That is, the bell of your video ring is now ready to be transferred to another person.
Frequent questions
Yes, restoring a video ring bell will eliminate all its images and settings, including Wi-Fi configuration.
Find the restart button on the video bell of your ring and press. Keep the restart button for the second time to connect your bell without having to restore it.
